When it comes to hardware accessories, everyone should be familiar with them, and they can be seen everywhere in our daily lives. However, if you want to say that the process of hardware accessories processing may not be familiar to everyone, hardware accessories manufacturers will take a look at the process of hardware accessories processing. .

Hardware accessories manufacturers

Hardware accessories processing flow:

1. The operator must first understand the correct operation method to avoid accidents, and check whether the clothing meets the requirements after entering the work post.

 

2. Before working, check whether the motion machinery is filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine idling for 1-3 minutes. Operation is strictly prohibited when the machine is faulty.

 

3. When changing the mold, the power must be turned off first, and the new mold can be installed after the machine stops. After debugging, check whether the mold is symmetrical and reasonable.

 

4. When the machine is working, it is forbidden to reach into the working area of ​​the slider, and it is strictly forbidden to pick up and place the workpiece by hand. Standard tools must be used when picking and placing the workpiece in the die. If abnormal sound or malfunction of the machine is found, turn off the power switch for inspection immediately.

 

5. Wait for unrelated personnel to leave the working area of ​​the machine and remove the debris from the workbench before turning on the power to start the machine.

Megosztás a facebookon